S&P INFRARED-125 Manual page 12

• The device can never be installed in the vertical position or di-
rectly attached to the ceiling or a similar structure (See Fig. 2).
• The device cannot be installed so that it projects heat upwards or
towards the ceiling (See Fig. 3).
• The device must not be mounted on an infl ammable surface,
like: wood, plastic, carpet, fi ber...etc.
• NB; Once installed, no infl ammable objects or objects affected
by heat must be within 2 meters of the device (curtains, towels,
plants, pets ... etc.).
• The device has been designed to be mounted at height and must
be installed adhering to the minimum distances from the ceiling,
fl oor and walls or objects to its sides (See Fig. 5).
• Do not install the device right underneath a power socket.
• The safety zones determined in local electrical installation stan-
dards, or safety standards applicable in your country must be
strictly observed. In any case, if it is installed in a bathroom, ne-
ver install it in the areas indicated as ZONE 0/1/2. It can be ins-
talled in Zone 3 as long as it is placed so that the device is not
within reach of anybody who is in the bath or the shower, inclu-
ding the switch activation cord (See Fig. 6).
• The device must not work in rooms or storage spaces with po-
tential dangers owing to the existence of gases from paints, che-
mical products, detergents, solvents, varnishes, etc., or other
highly infl ammable materials.
• After use, we recommend you leave the device to cool for at least
10 to 15 minutes before touching it.
• Before turning the device on for the fi rst time, check that all the
package's protective elements have been removed, including the
foam for protecting the heater tubes.
• For fi xed electrical installation, disconnection means must be
incorporated as per the installation regulations, with contact se-
paration in all poles that provide total disconnection under cate-
gory III overvoltage.
• If the power cable is damaged, it must be replaced with a cable
with the same plug.
12