StorageWorks RAID Array 410 Installation Manual page 9

For hp–ux
Hide thumbs Also See for RAID Array 410:
Table of Contents

Advertisement

Getting Started – RAID Array 410 for HP-UX
Verifying User Supplied Hardware and Software (System Requirements)
The StorageWorks RAID Array 410 Subsystem requires the following user-supplied
hardware and software:
HP 9000 Series 800 Computer System
An available Double-high Adapter Slot
The associated system hardware manual
Appropriate tools to service your computer
The HP-UX operating system V 9.04.
Verifying The StorageWorks RAID Array 410 Platform Kit and Subsystem
Components
The Storage Works RAID Array 410 Platform SWHK8-CB Kit provides the following
components:
This guide.
Release Notes
A HP-PB Fast Wide High Performance SCSI Adapter.
A BN21K-05 SCSI cable, three meters long, with a right-angle high-density 68-pin
connector on one end and a straight high-density 68-pin connector on the other.
The StorageWorks RAID Array 410 Subsystem SWXRA-Yx provides the following
components:
The SWXSC-AA Office Expansion RAID Enclosure User's Guide.
The SWXRC-04 RAID Controller User's Guide.
The StorageWorks RAID Array 410 Subsystem .
A cable for connecting the maintenance port of the controller to the serial port of a
personal computer.
9-pin to 25-pin adapter
Power Cable.
Keys.
RAID Array 410 Controller Firmware License Keys.
Perform a System Backup
Follow normal procedures to backup your system before installing the subsystem.
x
Retain the Firmware License Keys information in a safe place. It
may be required to reintialize the RAID Array Controller.
NOTE
EK–SMRA3–IG. C01

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RAID Array 410 and is the answer not in the manual?

Table of Contents