Start The Communications Program; Establish The Connection With The Controller; Show Initial Configuration - StorageWorks RAID Array 410 Installation Manual

Getting Started - RAID Array 410 for HP-UX

2.2.2 Start the Communications Program

1. Start the communications program on your PC.
2. Set the communications program to use the serial port that is connected to the controller.
3. Set the communications parameters to:
• 9600 baud
• 8 bits
• 1 stop bit
• No parity

2.2.3 Establish the Connection with the Controller

From your communication program, issue a connect command to establish a connection with
the controller, and then press the Enter key. You should see the CLI prompt, which looks
similar to
SWXRC>
2.3

Show Initial Configuration

The RAID Array 410 Subsystem has been preconfigured with a controller at ID0 (SCSI
target 0) and a single drive logical unit D0.
Enter the following command to verify the controller's parameters:
SWXRC> SHOW THIS_CONTROLLER FULL
The controller responds with a display similar to that shown below:
CONTROLLER:
SWXRC-04 CX44332211 FIRMWARE V25Z-0, HARDWARE A02
SCSI ADDRESS 7
TIME: NOT SET
HOST PORT:
⊇
SCSI TARGET(S) (0)
CACHE:
32 MEGABYTE WRITE CACHE, VERSION 2
⊄
CACHE IS GOOD
⊂
BATTERY IS GOOD
NO UNFLUSHED DATA IN CACHE
CACHE_FLUSH_TIMER=DEFAULT (10 SECONDS)
CACHE_POLICY=A
LICENSING INFORMATION:
⊆
RAID (RAID OPTION) IS ENABLED, LICENSE KEY IS VALID
∈
WBCA (WRITEBACK CACHE OPTION) IS ENABLED, LICENSE KEY IS VALID
∉
MIRR (DISK MIRRORING OPTION) IS ENABLED, LICENSE KEY IS VALID
EXTENDED INFORMATION:
TERMINAL SPEED 9600 BAUD,EIGHT BIT,NO PARITY,1 STOP BIT
OPERATION CONTROL:0000004
2–2
SECURITY STATE CODE:85780
EK–SMRA3–IG. C01