Resetting.the.handset.without.the.base; Changing.the.digital.security.code; Traveling.out.of.range - Uniden TRU9480 Series Owner's Manual

Resetting.the.Handset.without.the.Base

If.your.original.base.is.not.available.for.some.reason.(for.example,.it.is.lost.or.somehow.incapacitated),.you.can.still.
reset.the.handset.and.use.it.with.another.base..
) Press.and.hold.[ ].and.[#].for.more.than.5.seconds..
2) Move.the.cursor.to.select.BASE.UNAVAILABLE.and.then.press.the.OK.soft.key..
BASE.UNAVAILABLE.appears.
3) Move.the.cursor.to.select.YES,.and.then.press.the.OK.soft.key..ARE.YOU.SURE?.
appears.
4) Move.the.cursor.to.select.YES,.and.then.press.the.OK soft key. You will hear a confirmation tone. The hand-
set.will.delete.its.own.base.information.without.trying.to.contact.the.base..When.the.base.information.is.delet-
ed,.the.handset.displays.MODELS.VARY!.PLACE.HANDSET.ON.THE.BASE.FOR.REGISTRATION.OR.RE-
FER.TO.OWNER'S.MANUAL..Register.the.handset.to.the.new.base.(see.page.23).

Changing.the.Digital.Security.Code

The digital security code is an identification code used to connect the handset and the base. Your unit ships from the
manufacturer.with.a.preset.security.code..Resetting.this.code.is.not.normally.necessary..In.the.rare.situation.that.you.
suspect.another.cordless.telephone.is.using.the.same.security.code.or.if.you.are.instructed.to.change.this.code.by.a.
manufacturer's.Call.Center.Representative,.you.can.change.the.code.by:
. Perform."Resetting.the.Handset".for.all.of.your.handsets..
2. Re-register.each.handset.by.following.the.steps.on.page.23.

Traveling.Out.of.Range

During.a.call,.if.you.move.your.handset.too.far.away.from.your.base,.noise.may.increase..If.you.pass.the.range.limits.
of.the.base,.you.will.hear.a.beep.and.see.OUT.OF.RANGE.on.the.display,.and.then.the.handset.returns.to.standby.
7
B a s e U n a v a i l a b l e B a s e U n a v a i l a b l e
Y e s Y e s
N o N o
BACK BACK D E L E T E D E L E T E OK OK