Confirm Ethernet Dhcp Configuration - Watts AERCO Benchmark BMK750 Installation And Start-Up Manual
Natural gas, propane gas and dual fuel modulating & condensing boilers with edge i controller
Hide thumbs
Also See for AERCO Benchmark BMK750:
- Operation and service manual (213 pages) ,
- Installation and start-up manual (62 pages) ,
- Design manual (12 pages)
Table of Contents
Advertisement
Benchmark 750-6000 with Edge [i]: Install-Startup Manual
SECTION 3 – ONAER SETUP
3.1.3 Confirm Ethernet DHCP Configuration
Once you have confirmed that the Ethernet connection is working, complete the following steps
to confirm that the connection is active.
Confirming Ethernet DHCP Configuration Instructions
1. Connect your computer to the network jack that will be used by the Controller. Your computer
should be configured to automatically get a network address. Boot or reboot your computer.
2. Open a web browser and go to www.google.com.
3. Confirm that you can access the Google home page without entering a password, which
confirms that the connection is active, provides DHCP addresses, and allows access without
a password.
NOTE:
Static addresses are not required or recommended by AERCO. Reserved addresses are a
simpler solution.
OMM-144_B • GF-217 •
5/25/2020
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
Page 49 of 62
Advertisement
Table of Contents
