Confirming The Ethernet Connection - Watts AERCO Benchmark BMK750 Installation And Start-Up Manual
Natural gas, propane gas and dual fuel modulating & condensing boilers with edge i controller
Hide thumbs
Also See for AERCO Benchmark BMK750:
- Operation and service manual (213 pages) ,
- Installation and start-up manual (62 pages) ,
- Design manual (12 pages)
Table of Contents
Advertisement
Benchmark 750-6000 with Edge [i]: Install-Startup Manual
SECTION 3 – ONAER SETUP
Connecting The Ethernet Cable Instructions
USB JACK
ETHERNET JACK
Figure 3-1: Edge Controller – Left Side View
3.1.2 Confirming the Ethernet Connection
Refer to Figure 3-2, below, and complete the following instructions to confirm that the Ethernet
cable connection is working.
Confirming The Ethernet Connection Instructions
1. Powered the unit on and look for the green LED on the Controllers front face above the
onAER soft-key.
2. If the green LED is blinking periodically, there is normal communication with the network.
Figure 3-2: Edge Controller Front Face – Ethernet Indicator LED
OMM-144_B • GF-217 •
5/25/2020
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
GREEN
LED
Page 48 of 62
Advertisement
Table of Contents
