Confirming The Ethernet Connection; Confirm Ethernet Dhcp Configuration - Watts AERCO Benchmark OMM-0137 Installation And Start-Up Manual

Benchmark Platinum-Edge [ii]: Installation Manual
SECTION 3 – ONAER SETUP

3.1.2 Confirming the Ethernet Connection

Refer to Figure 3-3, below, and complete the following instructions to confirm that the Ethernet
cable connection is working.
Confirming the Ethernet Connection Instructions
1. Powered the unit on and look for the green LED on the Controllers front face above the
onAER soft-key.
2. If the green LED is blinking periodically, there is normal communication with the network.
Figure 3-3: Edge Controller Front Face – Ethernet Indicator LED

3.1.3 Confirm Ethernet DHCP Configuration

Once you have confirmed that the Ethernet connection is working, complete the following steps
to confirm that the connection is active.
Confirming Ethernet DHCP Configuration Instructions
1. Connect your computer to the network jack that will be used by the Edge Controller. Your
computer should be configured to automatically get a network address. Boot or reboot your
computer.
2. Open a web browser and go to www.google.com.
3. Confirm that you can access the Google home page without entering a password, which
confirms that the connection is active, provides DHCP addresses, and allows access
without a password.
NOTE:
Static addresses are not required or recommended by AERCO. Reserved addresses are a
simpler solution.
• GF-210 •
OMM-136_H
Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST
1/6/2021
GREEN
LED
Page 49 of 62