Confirming The Ethernet Connection - Watts AERCO Benchmark Series Installation And Start-Up Manual

Platinum boilers with edge [ii] controller natural gas, propane gas and dual fuel modulating & condensing boilers

Hide thumbs Also See for AERCO Benchmark Series:

Table of Contents

Benchmark Platinum-Edge [ii]: Installation Manual

SECTION 3 – ONAER SETUP

Connecting the Ethernet Cable Instructions

ETHERNET

JACK

Figure 3-1: Edge Controller – Left Side View

3.1.2 Confirming the Ethernet Connection

Refer to Figure 3-2, below, and complete the following instructions to confirm that the Ethernet

cable connection is working.

Confirming the Ethernet Connection Instructions

1. Powered the unit on and look for the green LED on the Controllers front face above the

onAER soft-key.

2. If the green LED is blinking periodically, there is normal communication with the network.

Figure 3-2: Edge Controller Front Face – Ethernet Indicator LED

OMM-136_E • GF-210 •

12/13/2019

Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST

GREEN

LED

Page 46 of 57

Table of Contents