Advertisement
Step 5
You will need
4 x Big Cam
Flat head
Nut (H2)
screwdriver
This is how a cam nut works........
The head of the cam
bolt goes into the open
mouth of the cam nut.
You then turn the cam
nut so it tightens over
the bolt.
Position Bottom Panel (P2) over Right Side Panel (P4) so that their grooves are aligned.
Fit Bottom Panel (P2), Front Rail (P5) & Back Rail (P6) to Right Side Panel (P4).
Insert 4 x Big Cam Nuts (H2) into Back Rail (P6), Front Rail (P5) and Right Side Panel (P4) and turn lockwise to lock.
Step 6
Slide Lower Back Panel (P13) & Upper Back Panel (P12) into grooves as shown.
www.fantasticfurniture.com.au
Cut Slot
(P12)
(P5)
(P6)
(P4)
(P13)
(P6)
(P4)
(P2)
(P2)
PAGE 7
Advertisement
