Table of Contents
Advertisement
Installation Guide
ATTENTION: THE SYSTEM MUST BE PLACED INTO SERVICE MODE BEFORE ANY UNDER HOOD
SERVICING IS DONE TO THE VEHICLE. IT IS THE RESPONSIBILITY OF THE VEHICLE'S OWNER TO
INSURE THAT THIS IS DONE.
ACCIDENTAL STARTING WHILE VEHICLE IS BEING SERVICED.
System Service Mode (Valet) - By Remote
Ignition
"On"
7 sec.
Battery Replacement
When the Battery Icon on the remote indicates that the battery is low the battery should be changed
promptly. Replace with quality 1.5volt "AAA" battery.
Slide
Lift
.
THE MANUFACTURER ACCEPTS NO RESPONSIBILITY FOR
This feature will disable the system from the remote transmitter. Use this feature must be
used when having the vehicle serviced. ( Oil change, Tune-up etc.)
ACTIVATE Service Mode (User Programmable Feature)
1 - Press and hold button #4 for 3 seconds. (The remote will beep twice)
2 - Press button #1 Five times or until the ? starts flashing on the LCD screen.
3 - Press button #3 and the ? symbol will come on solid.
4 - Press button #4 to exit User Program Mode.(System Is Now In Service Mode)
5 - The siren will chirp once and the LED's on the antenna will come on solid.
DEACTIVATE Service Mode
1 - Press and hold button #4 for 3 seconds. (The remote will beep twice)
2 - Press button #1 Five times or until the ? starts flashing on the LCD screen.
3 - Press button# 2 and the ? symbol will turn off.
4 - Press button# 4 to exit User Program Mode.(Serice Mode is Deactivated)
5 - The siren will chirp once and the LED's on the antenna will turn off.
Note: Remote starter functions will be disabled and the LED will be "On" steady.
The door locks and the trunk release will still be operational.
Emergency Service Mode - (Valet Mode)
This feature will disable the system except for locking and unlock functions.
This mode can also used if a remote is lost, damaged or if the system malfunctions.
ENTERING SERVICE MODE
1.Turn the ignition key to the "On" position then press and hold the Program Button on the
antenna for 5 seconds or until the siren chirps 5 times.
EXITING SERVICE MODE
1.Turn the ignition key to the "On" position then press and hold the Program Button for 5
seconds or until the siren chirps 2 times.
Note: Remote starter functions will be disabled and the LED will be "on" steady.
The door locks and the trunk release will still be operational.
+
-
OTHER FEATURES
1
13
Advertisement
Table of Contents
