Table of Contents
Advertisement
Installation Guide
Programming Overview
Program mode allows you to adjust the settings and options of your system.
Your system has been intelligently designed by installers with years of experience. The system's default settings
do not require any program changes in most cases. However, this system does incorporate a highly advanced
programming system that includes 4 menus with numerous options and settings that can be easily adjusted for
custom installations and applications.
Menu 1 - User Settings - Page 8
This program menu contains settings that adjust the way the system operates for the user.
Menu 2 - Alarm Settings - Page 9
This program menu contains settings that adjust the way the system operates for the user.
Menu 3 - Starter Settings - Page 10
This menu controls features and settings associated with remote car starter applications.
Menu 4 - Tach Settings - Page 11
This menu allows the programming of the tach signal and the manual adjustment of that setting.
Entering Program Mode
To Enter Program Mode
1) Make sure ignition is in the off position.
2) Within three seconds turn the key ON - OFF - ON - OFF - ON. Leave in the "ON" position.
3) Press and release the Program Button on the antenna one time.
st
4) The park lights will come on and the siren will chirp to confirm entering Program Mode.
5) Select the Desired Program Menu:
Press Button #1
Press Button #2
Press Button #3
Press Button #4
6) The selected mode will be confirmed by a siren chirp and one park light flash.
7) The Program Menu may be changed at any time by pressing the transmitter buttons as above, this allows
the installer to change a setting from one menu, then quickly jump to another menu and change another
setting without re-entering the Program Mode.
8) To exit Program Mode, Turn the ignition key "OFF" or wait 30 second and the system will exit automatically.
This will be confirmed by one long siren chirp and park light flash.
Note: If unit does not enter Program Mode, turn the ignition off then repeat steps 1-4.
** The first ignition(Blue wire) MUST be connected to the vehicle's first ignition wire. If it is not connected it
will not be possible to enter the Program Modes.
Changing the Programmable Settings
To Select and Change A Program Setting:
1) Enter Program Mode.
d
2) Select the desired Program Menu. (See pages 8 - 11)
3) Press & release the Program Button the correct number of times to select the desired Program
Setting(as listed on pages 8 - 11). The park lights will flash and the siren will chirp to indicate the current
setting that is selected.
4) Press and hold the Program Button until the parking lights / siren confirm the selected setting. The park
lights will flash and the siren will chirp to indicate the option selected within the setting.
5) Turn the ignition key "Off" to exit Program Mode.
Note: This procedure is listed in detail below each program setting on pages 8 - 11.
SYSTEM RESET
STEP 1 - Within three seconds turn the key ON-OFF-ON-OFF-ON (Leaving Key ON).
STEP 2 - Press and release the Program Button.
STEP 3 -The park lights will turn ON.
STEP 4 - Press the Program Button a second time and hold for 8 seconds until the park lights flash and the
siren will chirps three times. The system is now re-set to factory defaults.
Note: Reset to defaults does not delete the transmitters from memory.
User Options See Page 8
Alarm Option See Page 9
Remote Start Options See Page 10
Tach Adjustment Menu See Page 11
PROGRAMMING
7
Advertisement
Table of Contents
