Table of Contents
Advertisement
Installation Guide
Remote Start
1.Press and release Button #3 on the Remote Transmitter.
2.The Park lights will flash and the siren will chirp one time.
3. The remote will beep 3 times and the Key Icon will begin flashing.
4.When the vehicle has started, the system will flash the park lights four times and then
remain "On" while the vehicle is running.
5. The Runtime Bar Graph will appear on the LCD screen and begin counting down.
6. The vehicle will continue to run for the programmed runtime. (Normally 15 minutes).
Extended Run Time
1.Press and release Button #3 while the vehicle is running by the remote starter..
2.The park lights will flash and the siren will chirp one time to confirm that the runtime has
been extended. The system will reset the run time, (Normally 15 minutes).
Remote Stop
1.Press and hold Button #3 for three seconds. The remote starter will shut down.
2.The park lights will flash and the siren will chirp two times.
3. The transmitter will beep to verify the status of the alarm. (Armed or Disarmed)
Note: Pressing the brake pedal or opening hood will also stop the vehicle.
Idle Mode
1.Press and release Button #1 while the vehicle is running by the ignition key.
2.The park lights will turn on and the siren will chirp once.
3. The Remote will beep and the Run Time Bar Graph will light up.
4.Turn the ignition key "Off" and the vehicle will continue to run.
5. Exit the vehicle and leave it running safely without the keys in the ignition.
Note: Always lock the doors while the vehicle is left running.
Timer Mode
1. Press and release Button #4, then press and hold Button #3 for 5 seconds.
2. The Park lights will turn "On" and the start cycle can be selected.
1 hour cycle or 0C
2 hour cycle or -5C
3 hour cycle or -15C
4 hour cycle or -25C
3.The system will start the vehicle at selected start cycle for up to 24 hours.
TO CANCEL TIMER MODE
1.Press and release Button #3, then press and hold Button #4 seconds.
2.The park light will flash and the siren will chirp two times.
3. Starting the vehicle with the key or by the remote will also cancel Timer Mode.
Start Fault Indicator
If the Key Icon in the remote's Program Menu is flashing, the remote starter has been
disabled. This can be because of various inputs including hood open, brake active, tach
lockout or the system is in Service Mode.(Valet Mode)
When the remote start button is pressed in this mode, the remote will respond by giving 3
beeps and flashing the Key Icon in the Program Window. The Key Icon on the top of the
display will not be illuminated.
Note: The vehicle's start fault condition must be corrected in order to remote start.
OPERATIONS
Press Button #1
1 Park light flash
Press Button #2
2 Park light flashes
Press Button #3
3 Park light flashes
Press Button #4
4 Park light flashes
15
Advertisement
Table of Contents
