Ultra Start 4500 Installation Manual page 2

TABLE OF CONTENTS
4500 Wiring Diagram
Pre-Installation
Components
Recommended Pre-Installation Procedures
Recommended Install procedures
Wire Connectors
6 Pin Connector
14 Pin Connector
4 Pin Red Connector
4 Pin Blue Connector
Jumper Selections
Installation
Basic Installation - Quick start
Plugging In The Module
Auto Tach Learn
Shock Sensor Programming
Programming
Program Overview & System Reset
Program Menu 1 (User Settings)
Program Menu 2 (Alarm Settings)
Program Menu 3 (Starter Settings)
Program Menu 4 (Tach Settings)
Programming The Transmitter
Other Features And Operations
Transmitter Operation
Timer Mode
Reservation Mode (Manual Transmission Only)
Service Mode (Valet Mode)
Battery Replacement
System Operation
Relay Diagrams
DIAGNOSTICS
PARK LIGHTS
3 Flashes Series of 3 Flashes
3 Slow Flashes LED's On Solid
4 Slow Flashes Series of 4 Flashes
5 Flashes Series of 5 Flashes
5 Slow Flashes Series of 5 Flashes
6 Flashes Series of 6 Flashes
7 Flashes Series of 7 Flashes
8 Flashes Series of 8 Flashes
If the remote starter has a failed start attempt or if a safety input is activated the Diagnostic Memory will store up
to four shutdowns in memory. This information can then be accessed to determine the source of the shutdown.
To Enter Diagnostic Mode:
1 - Turn the ignition on wait two seconds then turn off. Press the Program Button and release.
2 - The system will respond with three park light flashes and the siren will chirp the
same number of times as the events in memory. ( Maximum four events, four chirps)
Note: If the siren does not chirp, there are no events in memory.
3 - Press the Program Button once to view the last shut down code. The siren will chirp once to
confirm code one. (If the siren does not chirp, there are no codes in memory).
4 - The LED's on the antenna will flash a code corresponding to a shut down trigger. Press the
Program Button again to check the second code. The siren will chirp twice to confirm code two.
5 - To Clear Diagnostic Memory. While in Diagnostic Mode press and hold the Program Button for
five seconds. The park lights will flash and the siren will chirp once.
Note: Once diagnostic memory has 4 improper shutdown events in memory, the system will not
record any further shutdown events until the system memory has been cleared.
2
STATUS LED
Installation Guide
DIAGNOSTIC CODE
Door Opened "M" Models
System Is In Service Mode
Not in Reservation Mode "M" units
Hood Pin Opened
Ignition On During Start Attempt
Brake Pedal Shutdown
Tach Lock-Out
3 Start Attempts with no start
Page 3
Page 4
Page 5
Page 6-7
Page 7-11
Page 12- 13
Page 14-15
Page 16