Powering Devices On; Setting Ip Addresses For The Codec - Huawei RP100 Commissioning Manual

HUAWEI RP100&RP200 Room Presence
Commissioning Guide

2.3 Powering Devices On

After unpacking cartons, check whether any devices are dead on arrival (D.O.A). If any D.O.A
device is found, protect the site and take a picture for the record and immediately contact the
supply chain personnel.
and their qualification criteria.
Table 2-3 Devices to be powered on
Device
HD display
Codec
HD camera

2.4 Setting IP Addresses for the Codec

Step 1 Connect a computer directly to the codec whose IP address needs to be modified. Change the
computer's IP address to be in the same network segment as that of the codec's default IP address
192.168.1.1.
Figure 2-2 Connecting the computer to the codec
Step 2 Connect the codec's standard power adapter to a power supply. Set the power switch on the codec
to ON so that the codec automatically starts after it is powered on.
Step 3 Log in to the codec web interface. By default, the user name and password are admin and
Change_Me, respectively.
Issue 01 (2015-02-12)
Table 2-3 describes the devices need to be powered on for inspection
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Deployment Preparation
Qualification Criteria
The HD displays are powered on properly,
and HDMI and VGA video sources are
displayed without artifacts.
The remote controlled UI of the codec is
displayed on the HD display.
The images collected by the HD camera are
displayed on the HD display.
9