Powering On The Dp300 - Huawei DP300 User Manual

Desktop presence

Hide thumbs Also See for DP300:

Table of Contents

HUAWEI DP300 Desktop Presence

User Guide

After connecting all the required devices, connect the power supply.

Powering On

Check whether the power cable and the power adapter are connected to the relevant devices

properly. Ensure that:

l When the DP300 is powered on, ensure that the power cable is connected to the DP300

l Before disconnecting the external power supply (for example, the power supply from a power

If you power on the DP300 for the first time, connect the power adapter to the power supply and

switch the power switch on the right panel to the ON position. Or tap the power button in the

lower right corner of the display and power on the DP300 as prompted.

During the DP300 startup, its display is started first and enters the PC mode. About 2 minutes

later, the conferencing system is started.

Switching to the VideoConferencing Mode

The DP300 mode can be switched after the conferencing system is started.

Tap

Then, the display can be used as the screen for interacting with the conferencing system.

In this case, the display becomes the touchscreen by default.

Issue 01 (2015-09-15)

The voltage of the alternating current ranges from 100 V to 240 V and the frequency of the

alternating current ranges from 50 Hz to 60 Hz.

The sequence of and voltage difference between the live wire, neutral wire, and ground

cable comply with the relevant international standards. In addition, ensure that the ground

cable is properly grounded.

NOTICE

securely to prevent power disconnection.

socket), power off the DP300 properly.

in the lower right corner of the display to switch PC mode to videoconferencing mode.

Huawei Proprietary and Confidential

Powering On the DP300

4 Powering On the DP300

Table of Contents