Huawei RP100 Commissioning Manual page 31

HUAWEI RP100&RP200 Room Presence
Commissioning Guide
To adjust the HD display support for the RP200-46S and RP200-55S, perform the following
steps:
Step 1 Remove the screws and washers using an H5 Allen wrench.
Step 2 Partially tighten the screws at the HD display support joints in the holes silk-screened with the
number that matches the HD display you are using.
l If you are using an RP200-46S, you do not need to adjust the support, as shown in
l If you are using an RP200-55S, align the holes on the horizontal bars with the holes silk-
Figure 3-12 Adjusting the HD display support
----End
Issue 01 (2015-02-12)
NOTE
l Before the support is delivered, screws are fastened in the holes silk-screened with 3. When using HD
display 3, you do not need to adjust the support.
l The left and right sides of the dual-screen HD display support are symmetrical. Therefore, the methods
for adjusting the two sides are the same. The following section uses the left side of the support as an
example.
3-12.
screened with 2 on the L and R bars.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Installation
Figure
24