Polaris 2880056 Manual
Polaris 2880056 Manual

Polaris 2880056 Manual

Sportsman ace trailerable cover kit

Advertisement

SPORTSMAN ACE TRAILERABLE
COVER KIT
P/N 2880056
Application
SPORTSMAN ACE
Before you begin, read these instructions and check to be sure all parts and tools are accounted for. Please retain these installation
instructions for future reference and parts ordering information.

Kit Contents:

Qty
1
1
APPROXIMATE ASSEMBLY TIME: 5 minutes
IMPORTANT: For your safety, and to ensure a satisfactory installation, perform all installation steps
correctly in the sequence as shown on the attached instructions.
Do not carry sharp or pointed objects.

INSTALLATION INSTRUCTIONS:

1. If trailering vehicle, make sure vehicle is positioned on the trailer in a forward-facing orientation. Place the
vehicle in ''PARK''. Turn the key to "OFF" position and remove from the vehicle.
2. Connect the velcro near the ratchet to the velcro on the cover. This will prevent the ratchet from damaging
the unit while installing the cover.
3. Connect the velcro wrap on the inside of the cover to the horizontal bar. Drape the cover over the vehicle.
NOTE: Polaris Star logo should face forward on the vehicle.
4. Pull the bottom edge of the cover down as far as possible all the way around the vehicle.
5. Buckle the bottom webbing together at front of the
vehicle. Figure 1.
Part Description
Cover
Instructions
Part Number
2880056
9924901
Bottom Webbing
Figure 1
-1-
Buckle

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 2880056 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Polaris 2880056

  • Page 1 3. Connect the velcro wrap on the inside of the cover to the horizontal bar. Drape the cover over the vehicle. NOTE: Polaris Star logo should face forward on the vehicle. 4. Pull the bottom edge of the cover down as far as possible all the way around the vehicle.
  • Page 2 6. Disconnect the ratchet from the velcro on the cover. At the rear of vehicle, thread the webbing at the bottom of the cover through the loop of the vertical hanging strap and thread into ratchet. Figure 2. Loop of the Vertical Hanging Strap Figure 2 7.

Table of Contents