Table of Contents
Advertisement
Electrical Connections
The DMD66 is fitted with a Manual Dual Voltage Selection Switch, and can be connected
into a standard 16amp 110v, or 13amp 230v supply once the correct plug has been fitted.
To reduce the risk of shock, it is recommended to use a suitable RCD (residual current
device).
230 Volt Mode
Connect the mains lead to a standard, 230 Volt (50Hz) electrical supply through an ap-
proved 13 amp BS 1363 plug, or a suitably fused isolator switch.
WARNING! THIS APPLIANCE MUST BE EARTHED
IMPORTANT: Wires in the mains lead are coloured in accordance with the following code:
As the colours of the flexible lead of this appliance may not correspond with the coloured
markings identifying terminals in your plug, or your mains supply, proceed as follows:
•
Connect GREEN & YELLOW coloured cord to plug terminal marked with a
letter "E" or Earth symbol "
•
Connect BROWN cord to terminal marked with a letter "L" or coloured RED.
•
Connect BLUE cord to terminal marked with a letter "N" or coloured BLACK.
Fuse Rating
The fuse in the plug must be replaced with one of the same rating (13amp) and this re-
placement must be ASTA approved to BS1362.
110 Volt Mode
These models must be connected to a protected 110V supply, through a suitably approved
BS4343/IEC309-2 connector. On no account must a 230V, 13amp (BS1363) plug be used.
NOTE: If a portable 110V transformer is used, make sure it has a rated capacity sufficient to
take the load of the unit.
In the event that the unit is hard wired into the electrical system, it must be carried out in
accordance with IEE regulations.
IF YOU ARE IN ANY DOUBT ABOUT ELECTRICAL CONNECTIONS, CONSULT A
NEVER ATTEMPT ELECTRICAL REPAIRS YOURSELF.
Green & Yellow .......... Earth
Blue .............................. Neutral
Brown .......................... Live
" or coloured GREEN or GREEN & YELLOW.
WARNING!
QUALIFIED ELECTRICIAN.
-4-
Advertisement
Table of Contents
