Subscribe to Our Youtube Channel
Related Manuals for Clarke DH10
Summary of Contents for Clarke DH10
- Page 1 10 LITRE DEHUMIDIFIER MODEL NO: DH10 PART NO: 6470650 OPERATION & MAINTENANCE INSTRUCTIONS LS0610...
-
Page 2: Environmental Protection
INTRODUCTION Thank you for purchasing this CLARKE product. Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service. -
Page 3: Safety Warnings
3. This appliance is designed to dehumidify residential environments and must not be used for any other purposes. 4. If the appliance requires repair, always contact your CLARKE dealer. Always insist on original spare parts. Repairs carried out by unauthorized persons may be dangerous and invalidate the guarantee. -
Page 4: Electrical Connections
ELECTRICAL CONNECTIONS WARNING! Read these electrical safety instructions thoroughly before connecting the product to the mains supply. Before switching the product on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate. This product is designed to operate on 230VAC 50Hz. -
Page 5: Positioning The Dehumidifier
OVERVIEW DESCRIPTION Control panel Handle Air outlet vent Filter cover / Air inlet Water tank POSITIONING THE DEHUMIDIFIER • Position the dehumidifier close to a mains supply socket. • A free space as shown must be left around the dehumidifier, so as not to block the air flow. -
Page 6: Operation
OPERATION BEFORE USE 1. Stand your dehumidifier upright for at least 2 hours prior to operating. 2. Remove the water tank then replace it. This will reset the sensors which may have been activated during transit. SWITCHING ON 1. Plug into the mains supply socket and switch on. -
Page 7: Switching Off
SWITCHING OFF Set the ON/OFF Switch to the OFF (O) position. EMPTYING THE WATER TANK 1. When the FULL indicator on the control panel illuminates, switch off and disconnect from the mains supply. 2. Carefully remove the water tank by placing your fingers in the channel underneath the tank and pulling forwards, as shown opposite. -
Page 8: Maintenance
MAINTENANCE WARNING: ALWAYS UNPLUG THE DEHUMIDIFIER BEFORE PERFORMING ANY CLEANING OR MAINTENANCE OPERATIONS. CLEANING THE CABINET • Use a soft damp cloth to clean the exterior. • Never use harsh chemicals or abrasive cleaning agents as these may damage the casing finish. CLEANING THE AIR FILTER 1. -
Page 9: Troubleshooting
TROUBLESHOOTING Cause Solution No operation Power cable Insert the plug into a power disconnected. socket. Water tank is full. Empty the water tank. Water tank is not seated Replace the tank correctly in properly. position. Dehumidified Filter is dirty. Clean the filter as described volume is small See page 8. -
Page 10: Technical Specification
• Electric fans for home, office and commercial use. • Air conditioners • Electric/Gas & Diesel fired space heaters for use in the home, workshop or commercial premises Please see your local Clarke stockist for details. Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... -
Page 11: Declaration Of Conformity
DECLARATION OF CONFORMITY Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
Need help?
Do you have a question about the DH10 and is the answer not in the manual?
Questions and answers