Related Manuals for Clarke YDK10
Summary of Contents for Clarke YDK10
- Page 1 10 LITRE DEHUMIDIFIER MODEL NO: YDK10 PART NO: 6470686 OPERATION & MAINTENANCE INSTRUCTIONS LS0617 - ISS 1 ORIGINAL INSTRUCTIONS...
-
Page 2: Environmental Protection
This guarantee is invalid if the dehumidifier has been tampered with, or not used for the function for which it was intended. Defective goods must be returned to their place of purchase. The dehumidifier must not be returned to Clarke international without prior permission. This guarantee does not effect your statutory rights. -
Page 3: Safety Warnings
11. Do not pull the cable or let it get pinched. 12. Do not let the cable become a hazard. 13. Replace the cable if it is damaged. 14. Speak to your Clarke supplier if repairs are necessary. 15. Repairs by unauthorised persons can be dangerous and invalidates the guarantee. -
Page 4: Electrical Connections
ELECTRICAL CONNECTIONS WARNING: READ THESE ELECTRICAL SAFETY INSTRUCTIONS FULLY BEFORE YOU CONNECT THE DEHUMIDIFIER TO THE MAINS SUPPLY. Before you switch the dehumidifier on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate. This dehumidifier operate on a 230VAC 50Hz supply. -
Page 5: Locating The Dehumidifier
OVERVIEW LOCATING THE DEHUMIDIFIER • Place the dehumidifier near a power outlet. • Space must be left around the dehumidifier, to let air flow in and out. • Do not pull on the cable. • Do not crush the cable. •... -
Page 6: Operation
OPERATION BEFORE USE 1. Stand your dehumidifier upright for a minimum of 1 hour before operating. 2. Connect the plug to the power supply. SWITCH ON/OFF 1. Set the ON/OFF Switch to the ON position. • The power indicator lights up. 2. -
Page 7: Continuous Drainage
CONTINUOUS DRAINAGE This function lets the dehumidifier work continuously without having to empty the water tank. 1. Turn the dehumidifier over and identify the continuous drainage port 2. Remove the plug from the continuous drainage port. 3. Insert the spring supplied into the drainage hose and then connect that end of the drainage hose to the drainage port. -
Page 8: Maintenance
MAINTENANCE WARNING: ALWAYS UNPLUG THE DEHUMIDIFIER BEFORE YOU CLEAN OR DO ANY MAINTENANCE OPERATIONS. STORAGE • Disconnect from the mains supply and empty the tank. • Clean and install the filter, see below. • Put a cover on the dehumidifier to stop dust getting inside. CLEANING THE CABINET •... -
Page 9: Troubleshooting
TROUBLESHOOTING Cause Solution No operation Power cable is Connect the plug to the power disconnected. supply. The tank is full. Empty the tank. The tank is not fitted Replace the tank correctly in properly. position. Dehumidifier The filter is dirty. Clean the filter. -
Page 10: Declaration Of Conformity
DECLARATION OF CONFORMITY Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com... - Page 11 Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...