Related Manuals for Clarke DH20
Summary of Contents for Clarke DH20
- Page 1 20 LITRE DEHUMIDIFIER MODEL NO: DH20 PART NO: 6470652 OPERATION & MAINTENANCE INSTRUCTIONS LS0510...
-
Page 2: Environmental Protection
INTRODUCTION Thank you for purchasing this CLARKE product. Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service. -
Page 3: Safety Warnings
3. This appliance is designed to dehumidify residential environments and must not be used for other purposes. 4. If the appliance requires repair, always contact your CLARKE dealer. Always insist on original spare parts. Repairs carried out by unauthorized persons may be dangerous and invalidate the guarantee. -
Page 4: Electrical Connections
ELECTRICAL CONNECTIONS WARNING! Read these electrical safety instructions thoroughly before connecting the product to the mains supply. Before switching the product on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate. This product is designed to operate on 230VAC 50Hz. -
Page 5: Positioning The Dehumidifier
OVERVIEW DESCRIPTION Control panel Handle Air vent Filter cover / Air inlet Water tank POSITIONING THE DEHUMIDIFIER • Position the dehumidifier close to a mains supply socket • A free space indicated must be left around the dehumidifier, so as not to block the air flow. -
Page 6: Operation
OPERATION SWITCHING ON Plug into the mains supply socket and switch on. The Automatic indicator will flash. Press the button. • The Automatic indicator will illuminate. SELECT MODE Press the button to cycle through the available modes. • The indicator light will illuminate above your selection. -
Page 7: Timer Operation
TIMER OPERATION Press the button to cycle through the timer options: 2 hours, 4 hours or 8 hours. After the time selected has elapsed the dehumidifier will switch off. NOTE: The timer function works in ALL modes. SWITCHING OFF Press the button. -
Page 8: Continuous Draining
CONTINUOUS DRAINING This function enables continuous dehumidifying without having to empty the water tank. PREPARATION FOR CONTINUOUS DRAINING: 1. Remove the water tank. 2. Make the hose opening. • To make the opening, prise the cover for the drain hose away using a screwdriver. -
Page 9: Maintenance
MAINTENANCE WARNING: ALWAYS UNPLUG THE DEHUMIDIFIER BEFORE PERFORMING ANY CLEANING OR MAINTENANCE OPERATIONS. CLEANING THE CABINET • Use a soft damp cloth to clean the exterior. • Never use harsh chemicals or abrasive cleaning agents as these may damage the casing finish. CLEANING THE AIR FILTER 1. -
Page 10: Troubleshooting
TROUBLESHOOTING Cause Solution No operation Power cable disconnected Insert the plug into a power socket. Water tank is full Empty the water tank. Water tank is not seated Replace the tank correctly in properly. position. Air vent closed. Open the air vent. Dehumidified Is the filter dirty? Clean the filter as specified. -
Page 11: Declaration Of Conformity
DECLARATION OF CONFORMITY Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...