KI WireWorks Tech Panel Assembly Instructions

Advertisement

Quick Links

July, 2004
KI
1330 Bellevue Street
P.O. Box 8100
Green Bay, Wisconsin 54308-8100
TEL (800) 424-2432
FAX (920) 468-0280
Assembly Instructions
WireWorks
®
Tech Panel

Tools Required:

3
" Allen Wrench
16

Definition

A WireWorks Tech Panel differs from a
standard WireWorks panel as follows:
1. Tech Panels do not utilize base
raceways on one or both sides
of panel.
2. Tech Panel bottom tiles extend down
an additional 6" in lieu of
the base raceway.
3. Tech Panels utilize plastic
horizontal light blocks instead of
steel horizontal rails wherever
possible. Figure 1.

Installing Tech Panels

1. Panel frame of tech panel assembles
in the same manner as standard
WireWorks panel.
Note: Every Tech Panel has steel
horizontals at top and bottom. Refer
to installation drawing to locate
middle rails.
2. Install plastic light blocks where
specified on installation drawing.
Figure 2.
Push tab on light block with finger,
no tools required, in towards pocket
of vertical post and seat both tabs
into the pockets (in which the top
rivet of the steel horizontal would
normally be located).
Note: Light blocks 42" and greater
require the installation of clips.
Figure 1
clip (to be installed on light
blocks 42" and greater)
plastic light blocks
Figure 2
plastic light block for
on-module overhead
storage, or
steel horizontal rail for
off-module.
plastic light block where
there isn't power at belt
height, or
steel horizontal rail for
power at belt height.
tile hook

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WireWorks Tech Panel and is the answer not in the manual?

Questions and answers

Summary of Contents for KI WireWorks Tech Panel

  • Page 1 Green Bay, Wisconsin 54308-8100 Definition on-module overhead storage, or TEL (800) 424-2432 A WireWorks Tech Panel differs from a steel horizontal rail for standard WireWorks panel as follows: FAX (920) 468-0280 off-module. 1. Tech Panels do not utilize base raceways on one or both sides of panel.
  • Page 2 WireWorks ® Tech Panel Assemble units as described herein only. To do otherwise may result in instability. All screws, nuts and bolts must be tightened securely and must be checked periodically after assembly. Failure to assemble properly, or to secure parts may result in assembly failure and injury.
  • Page 3 WireWorks ® Tech Panel Assemble units as described herein only. To do otherwise may result in instability. All screws, nuts and bolts must be tightened securely and must be checked periodically after assembly. Failure to assemble properly, or to secure parts may result in assembly failure and injury.
  • Page 4 Green Bay, Wisconsin 54308-8100 TEL (800) 424-2432 FAX (920) 468-0280 www.ki.com KI is a registered trademark of Krueger International, Inc. WireWorks is a registered trademark of Krueger International, Inc. © KI 2004 All Rights Reserved Litho in USA Code KI-61277R2/TM/GT/704...

Table of Contents