Wi r e Wo r k s
center support
Figure 1
Figure 2
1330 Bellevue Street • P. O. Box 8100 • Green Bay, WI 54308-8100 • Tel 1-800-424-2432 • www.ki.com
© 2004 KI All Rights Reserved • Litho in USA • Code KI-61594R2/TM/GT/1004
A s s e m b l y I n s t r u c t i o n s
B a s e R a c e w a y C e n t e r S u p p o r t
®
steel horizontal
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and injury.
A u g u s t 2 0 0 4
Important: Electrical wireway
must be removed prior to
installation of center support
bracket.
1. Position raceway center support
near the center of the panel under
the lowest steel horizontal as
shown below. Make sure the
larger leg of the bracket is
towards the top (Figure 1).
2. Slide the support into the open-
ing of the horizontal (Figure 2).
Note: Raceway side door
removed for clarity.