KI WorkUp HF Assembly Instructions Manual

Motor-Operated Furnishing
-FOR COMMERICAL USE ONLY-
Detail A - Roller Foot Option
leveling
glide
M8 x 18
screw
locking
caster
foot
Figure 1
Detail B
mm
flat
washer
locking
caster
column
Assembly Instructions
WorkUp Adjustable Table
®
Model HF
September 2024
Tools Required
• #2 Phillips Screwdriver
• #3 Phillips Screwdriver
• 5 mm Hex Key
Note: Before discarding any
packaging confirm all components
received against the packing list.
Table assembly should be done on a
soft, protective surface.
Note: When tightening the
M8 x 18 mm screws at the bottom of
the foot and into the leg column, first
twist in all four screws "finger tight",
then tighten the screws one quarter
turn at a time using a diagonal
tightening pattern as shown in
Detail A. Repeat the diagonal
pattern until all four screws are
tight (Figure 1 & Detail A).
Feet-to-Columns Assembly
1. Set the column on end with the
smaller (inner) square tube on the
floor. The threaded holes visible
on the end of the column will be in
a rectangular (not square) pattern
(Figure 1).
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Last order date: 3-31-25
Last ship date: 6-30-25
Note: If the roller foot option was
purchased, one foot will have
pre-assembled rollers. Make sure to
install the foot with rollers (if present)
on the desired side of the table, or
disassembly and reassembly may be
required (Detail A).
2. Place the foot over the column end
so the column fits into the square
hole in the foot. The slotted holes
in the foot should line up with the
four holes in the column end. If not
the foot needs to be removed and
repositioned at 90 degrees
(Figure 1).
3. Attach the foot using four
M8 x 18 mm screws and four 8 mm
flat washers, tightening each screw
one quarter turn at a time in a
diagonal pattern until all four screws
are tight (Figure 1 & Detail A).
4. If the table being assembled is a
caster leg unit, proceed to "Caster
Installation" instructions on this
page, otherwise proceed to "Glide
Installation" instructions on this page.
Caster Installation
1. Thread the stem of each stem-mount
locking caster into the threaded
inserts at the underside of one foot.
Tighten the casters to the underside
of the table using a 12 mm hex
wrench. Repeat this step to install the
casters to the second foot (Figure 1).
2. Proceed to "Tabletop Support-to-
Columns Assembly" instructions on
the next page.
Glide Installation
1. Thread the stem of each leveling
glide into the threaded inserts at the
underside of each foot (Figure 1).
2. Proceed to "Tabletop Support-to-
Columns Assembly" instructions on
the next page.