KI WireWorks Assembly Instructions

Assembly Instructions
WireWorks & StudioWorks Panel Systems
WireWorks
Figure 1
aluminum
top cap
Figure 2
Assembly Instructions
Center Mounted Cubby
& StudioWorks
® ®
Center Mounted Cubby
drill / "
3
8
holes
top
horizontal
rail
frame
assembly
drill / " 5
8
holes
top
horizontal
rail
frame
assembly
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Panel System
January 2013

Required Tools:

Required Tools:
?
Power Drill
•
?
3/8 high-speed drill bit (for steel)
•
?
5/8 hole saw
•
?
Phillips screw driver (install
•
mounting weldments)
?
Open-end wrench (install cubby
•
to horizontal rail)

Cubby Mounting Holes

Cubby Mounting Holes
1. Remove top cap and panel tiles
1. Remove top cap and panel tiles.
2. Measure and mark two mounting
2. Measure and mark two mounting
hole locations along the horizontal
hole locations along the horizontal
rail as shown (Figure 1). The
rail as shown (Figure 1). The
distance between the center of the
distance between the center of
holes will be 24", 30" or 36"
the holes will be 24", 30" or 36"
depending on the Cubby size (check
depending on the Cubby size (check
bottom of Cubby assembly for
bottom of Cubby assembly for
mounting distance). The two holes
mounting distance). The two holes
can be located anywhere along the
can be located anywhere along the
top horizontal rail, but no closer than
top horizontal rail, but no closer than
5" to the end of the rail where there
5" to the end of the rail where there
is no material. In most cases the
is no material. In most cases the
pair of holes will be centered along
pair of holes will be centered along
the horizontal rail or panel as shown
the horizontal rail or panel as shown
(Figure 1).
(Figure 1).
Note:
Note: It is very important that the
center distance between the holes is
center distance between the holes is
accurately located to within +/-
accurately located to within +/-
1/32" (.032").
(.032").
3. Using a 3/8 bit, drill two mounting
3. Using a
holes entirely through both walls of
holes entirely through both walls of
the top horizontal rail at the locations
the top horizontal rail at the locations
marked.
marked (Figure 1).
4. Install the aluminum top cap and
4. Install the aluminum top cap and
mark the hole locations as before.
mark the hole locations as before
(Figure 2).
5. Using a 5/8 hole saw, drill two
holes through the aluminum top cap
5. Using a
(Figure 2).
through the aluminum top cap
(Figure 2).
Power Drill
" high-speed drill bit (for steel)
/
3
8
" hole saw
/
5
8
Phillips screw driver (install
mounting weldments)
Open-end wrench (install cubby to
horizontal rail)
It is very important that the
/ "
1
32
/ " bit, drill two mounting
3
8
/ " hole saw, drill two holes
5
8