Maintenance Schedule - GBC FALCON 60 C Instruction Manual

F 60 C Operation and Maintenance Manual
8.0 Maintenance
GBC Films Group laminators require minimal
maintenance. However, regular maintenance is essential
to keep any piece of precision machinery at peak
performance. A maintenance schedule and a section of
procedures are included in this section.
Do not wear ties, loose fit clothing or
dangling jewelry while operating or
servicing the laminator. These items can get
caught in the nip and choke you or you can
be crushed or burned.
INFORMATION
Improper maintenance, can
result in poor output quality.
Remove power from the laminator before
servicing. You can be severely shocked,
electrocuted or cause a fire.
© April 2001 General Binding Corporation
WARNING
ELECTRICAL
S H O C K

8.1 Maintenance Schedule

INFORMATION
Below is a recommended maintenance
schedule. Before performing any of the steps
listed, read through the procedures first.
Please follow the instructions pertaining to
the step you are performing.
Daily
• Clean the rollers
( See cleaning in this section )
• Inspect the electrical cord for damage.
( If damaged, you should replace or repair it
immediately )
• Inspect the footswitch cord for damage.
( If damaged, you should replace or repair it
immediately )
Monthly
• Adjust the nip if needed.
( performed by service technician )
• Check the chain tension.
( See chain tensioning in this section )
Maintenance
Page 8 - 1