Load/ Unload Film - GBC FALCON 60 C Instruction Manual

F 60 C Operation and Maintenance Manual

5.3 Load/ Unload film

The film supply shafts, commonly known as unwind
shafts, pivot out for ease of loading and unloading of film.
Always pay particular attention to which side is the
adhesive side and which side is the carrier side. The
adhesive side will always face away from the rollers. Refer
to Figure 5.3.1 and Figure 5.3.2
E nsure the roll of lam inate is loaded
properly on the unw ind shaft.
E xposed adhesive should be facing
aw ay from the rollers.
T his w ill prevent hours of roll cleaning!
Figure 5.3.1 PSA Poly-in
C raft
paper
© April 2001 General Binding Corporation
C AU T IO N
P S A
film
P S A
P o ly - in
Figure 5.3.2 PSA Poly-out
M o u n t
a d h e sive
IN F O R M AT IO N
T he Poly-in/ Poly-out diagram s refer to the
upper rolls of film only. T he m ount adhesive
and craft papers are for reference only.
IN F O R M AT IO N
T he core grip w ith the O -ring on it should
alw ays be on the inside ( pivot side ) of the
unw ind shaft. T he O -R ing is a core stop.
Operations
P S A
film
P S A
P o ly - o u t
Page 5 - 5