Clean Cabinets And Covers - GBC FALCON 60 C Instruction Manual

F 60 C Operation and Maintenance Manual
c) Set motor direction to REV.
(reverse)
d) For pressure sensitive adhesives: put the rubber
gloves on and use isopropyl alcohol and a
terry cloth towel to rub the adhesive off.
Excessive pressure can destroy the silicone
layer by pressing to hard or scrubbing
too long in one spot.
W h en op erating th e lam inator u sin g the
footsw itch, keep hand s and fin gers
aw ay from th e n ip of the rollers.
Y ou m ay b e C R U S H E D !
d) Use the footswitch to rotate the rollers when
finished cleaning the exposed area.
© April 2001 General Binding Corporation
(forward)
CAUTION
W A R N IN G

8.3 Clean cabinets and covers

Remove power from the laminator before
cleaning. You can be severely shocked,
electrocuted or cause a fire.
a) Use a damp cotton terry cloth ( water only ),
clean the exterior of the laminator.
b) If water is not strong enough, you may use a
mild dishwashing detergent with water and a
cotton terry cloth.
Do not use liquid or aerosol cleaners on the
laminator. Do not spill liquid of any kind on
the laminator. You can be severely shocked,
electrocuted or cause a fire. Use only a damp
cloth for cleaning unless other wise
specified.
Maintenance
ELECTRICAL
S H O C K
ELECTRICAL
S H O C K
Page 8 - 3