Safety Features - GBC FALCON 60 C Instruction Manual

Table of Contents

F 60 C Operation and Maintenance Manual

1.3 Safety features

The laminator is equipped with four emergency

stops ( E-STOP ). Two are located at the front of the

cabinets and two are at the rear of the cabinets. Refer to

To engage an E-STOP, press down on any of the

four. Any E-STOP, when engaged, removes power to

the laminator.

INFORMATION

The machine will only operate if all four

E-STOPS are in the unlatched position.

E -S T O P

To continue operation, all E-STOPs must be in

the unlatched position. To reset, twist the E-STOP 1/4

turn counter clockwise.

Press RESET located on the control side cabinet

at the rear of the machine just above the main power on/

off.

P O

E R

The nip area is protected by a electric photo-eye

which shoots a beam in front of the nip across the width

of the rollers. When this beam is broken, power to the

drive motor is removed. The object must be removed to

clear the photo-eye. The motor engage switch must be

pressed again to continue motor operation.

PHOTO-EYE

Safety

Reset

Page 1 - 3

Table of Contents