System Operation Overview; Description Of Set Up Menu Screens - Advantage Controls MICROtron MICRO-C Manual

V.

System Operation Overview

MICROtron controllers have two modes of operation, RUN and SET UP. Both the RUN and SET UP menus
are circular. Pressing the DOWN key in either menu will display the next line of information on the display.
After the last item in a menu has been displayed, pressing the DOWN key will return the display to the top
line of that menu.
RUN MODE - This mode is for normal operation. The control relays will only be automatically activated
in this mode. In the RUN mode the display will read system values. If an alarm is present
the display flashes with the alarm status.
The RUN menu will display values such as conductivity, day, time, date and other values
depending upon the features present on the unit. The unit will automatically return to the
RUN mode if no keys are pressed for three minutes.
SET UP MODE - This mode is used to make adjustments to settings and readings on the controller. To
access the SET UP mode from the RUN screen, press the MENU key. Use the up or
down arrow to scroll through the various SET UP menus. When you want to enter a
specific SET UP menu, press the ENTER key. Once you have entered a SET UP sub
menu you will be able to step through that menu's options with the down arrow key.
Relays may be forced on while in the SET UP mode. Press the desired relay test key to
force it on. Press it a second time to turn it off. The relay will activate upon exiting the
Manual Relay submenu.

Description of SET UP Menu Screens

The SET UP menu is the main menu circle of set up sub-menus used to customize your unit to the particular
parameters needed for your installation. Listed on the following pages is a description and menu map of each
SET UP menu.
NOTES:
1. Your unit may not have all of the SET UP menus listed depending upon your model number.
2. After you press ENTER or CLEAR to change a numerical value in the SET UP menu, use the
number keys to define the new value. Press ENTER again to enter the new value.
3. When entering new numeric values, all available digits (characters) must be entered. The number
of available digits depends upon the scale of operation. Position of cursor indicates number of
digits to be entered.
7