Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Norac Manuals
  4. Control Systems
  5. UC4.5
  6. Installation manual

Norac UC4.5 Installation Manual

Spray height control system, agco terragator standard control, benson boom
Hide thumbs Also See for UC4.5:

Advertisement

Quick Links

Download this manual
AGCO TerraGator Standard Control
Benson Boom
Installation Manual
TG1

Advertisement

loading
Need help?

Need help?

Do you have a question about the UC4.5 and is the answer not in the manual?

Questions and answers

Related Manuals for Norac UC4.5

Summary of Contents for Norac UC4.5

  • Page 1 AGCO TerraGator Standard Control Benson Boom Installation Manual...
  • Page 2 Reorder P/N: UC4.5-BC-TG1-INST Rev B (AGCO TerraGator Standard Control Benson Boom) NOTICE: NORAC Systems International Inc. reserves the right to improve products and their specifications without notice and without the requirement to update products sold previously. Every effort has been made to ensure the accuracy of the information...

  • Page 3: Table Of Contents

    Contents Introduction ........................ 1     General UC4.5 System Layout ................. 2     Kit Parts ........................3     Ultrasonic Max™ Sensor Installation ..............5     Electrical Installation ....................6     Software Setup ......................9    ...

  • Page 4: Introduction

    Introduction Congratulations on your purchase of the NORAC UC4.5 Spray Height Control System. This system is manufactured with top quality components and is engineered using the latest technology to provide operating reliability unmatched for years to come. When properly used the system can provide protection from sprayer boom damage, improve sprayer efficiency, and ensure chemicals are applied correctly.

  • Page 5: General Uc4.5 System Layout

    General UC4.5 System Layout Figure 1 illustrates the general layout of the UC4.5 system components: Figure 1: General UC4.5 System Layout...

  • Page 6: Kit Parts

    Kit Parts Kit Overview Figure 2: TG1 System Parts...
  • Page 7 MANUAL INSTALLATION UC4.5 TERRAGATOR STANDARD CONTROL BENSON WET BOOM Do not use high speed power tools/drills when installing hardware. The use of dielectric grease is not recommended on any NORAC electrical connections. To ensure all stainless steel hardware does not gall or seize apply a light coating of the supplied Permatex Anti-seize grease to all threaded parts upon installation.

  • Page 8: Ultrasonic Max™ Sensor Installation

    2. Mount the sensor bracket onto the boom using B06. 3. Mount the NORAC ultrasonic MAX sensor into the sensor bracket and run the sensor cable either through hole in the back and behind the bracket. Ensure the cable is clear of moving parts.

  • Page 9: Electrical Installation

    A good spot to mount the UC4.5 control panel is on the right hand side of the cab to the Roll Over Protection Bar. Four pilot holes for the screws provided need to be drilled to facilitate the control panel mounting.
  • Page 10 2. Connect the UC4.5 power cable (C10) to the UC4.5 control panel in the sprayer cab. Ensure both plugs (P16 and P4) are connected to the panel. Cable tie C10 to the RAM mount to help provide strain relief. Ensure the UC4.5 control panel’s power is OFF for the remaining installation (Bottom of switch pressed IN).
  • Page 11 9. Route cables C16 and C19 to the hydraulic valve block. 10. Tee the 2-pin connectors on cable C17 into the TerraGator wiring at each of the valve coils as shown in Table 2. Table 2: Interface Connections NORAC Interface Label Cable Number TerraGator Coil Left Up...

  • Page 12: Software Setup

    2. If any functions do not work, review the hydraulic and electrical portions of this manual to check for proper installation. 3. Turn on the power for the UC4.5 Control Panel using the switch on the side of its chassis. 4. The procedure for the installation of the UC4.5 Spray Height Control system is now complete.

  • Page 13: Cable Drawings

    Cable Drawings ITEM C05: 43210-10 - CABLE UC5 NETWORK 18 AWG - 10M ITEM C06: 43220-10 - CABLE UC5 NETWORK 14 AWG - 10M...
  • Page 14 ITEM C09: 44651-55 – CABLE UC4.5 CABIN ENTRY TERRAGATOR STANDARD CONTROL...
  • Page 16 ITEM C10: 44650-61 - CABLE UC4.5 POWER TERRAGATOR STANDARD CONTROL...
  • Page 17 ITEM C11: 44651-54 - CABLE UC4.5 EXTENSION TERRAGATOR STANDARD CONTROL...
  • Page 18 ITEM C16A: 44658-69 - CABLE UC4 INTERFACE ROLL DT...
  • Page 19 ITEM C16B: 44658-118 - CABLE UC4.5 INTERFACE ROLL MP280...
  • Page 20 ITEM C19A: 44658-114 - CABLE UC4.5 INTERFACE STANDARD DT...
  • Page 21 ITEM C19B: 44658-115 - CABLE UC4.5 INTERFACE STANDARD MP280...
  • Page 22 7.10 ITEM C30: 43250-04 – CABLE UC5 BATTERY AMP FUSED...
  • Page 23 TOPCON Agriculture Canada 3702 Kinnear Place Saskatoon, SK S7P 0A6 TOPCON Agriculture Americas W5527 Hwy 106 Fort Atkinson, WI 53538 TOPCON Precision Agriculture Europe Avenida de la industria, 35, Tres Cantos, España Spain Support Phone: 888 979 9509 E-mail: tasupportn@topcon.com Web: www.norac.ca...