Avaya S8500 Installing And Configuring page 56

Chapter 5: IP interface configuration
Note:
While connected to the IPSI, type help or ? to obtain online help. Most
Note:
commands have two or three letter abbreviations.
5. Type ipsilogin and press Enter.
Note:
The craft login used on the IPSI has a different password from the craft login used
Note:
on the servers.
6. Log in as craft.
Prompt = [IPADMIN]:
7. Type show control interface and press Enter and then type show port 1 and
press Enter to see the current control interface settings.
8. To set the control interface, type set control interface ipaddr netmask and
press Enter, where ipaddr is the customer-provided IP address and netmask is the
customer provided subnet mask.
9. Type quit and press Enter to save the changes and exit the IPSI session.
10. Log back in to the IPSI using SSH.
11. Type show control interface and press Enter.
The system displays IP address, subnet mask, and default gateway information.
Verify that the proper information was entered.
12. If a default gateway is used, enter the gateway IP address with
set control gateway gatewayaddr, where gatewayaddr is the customer-provided
IP address for their gateway.
13. Type quit and press Enter to save the changes and exit the IPSI session.
56
Installing and Configuring the Avaya S8500 Server January 2008