ABB CoriolisMaster FCB100 Instruction Manual page 22

6 – EN CORIOLISMASTER FCX100, FCX400 SEALING OF DEVICES | IN/FCX100/FCX400/MID/OIML-XA REV. A
Lay seal wire
1
Fig. 5
1. Insert locking cylinder
rear housing cover.
2. Insert the seal wire 2
holding rod 1 such that both ends are the same length.
3. Tightly twist the seal wire
cylinder 3 to secure the locking cylinder
NOTICE
You should still be able to slightly move the locking
cylinder after it is secured with the seal wire.
4. Continue to twist the seal wire
on the front housing cover. Both ends of the seal wire
must be very close together and the twist loops should
be smaller than 1 cm.
5. Secure the locking cylinder
described in step 3.
2 3
3 on the holding rod 1
through the openings on the
2 right behind the locking
3 .
2 to the holding rod
on the front cover, as
3
1
2
3
G12352
on the
Fig. 6
6. Continue to twist the seal wire
hole screw
hole in the screw, guide the other end near the screw.
Tightly twist the seal wire
screw 3
7. Continue to twist the seal wire
hole screw
described previously.
8. Tightly twist both ends of the seal wire after the front
head hole screw
1
9. Place the seal approx. 5 cm from the front head hole
screw
2
together using sealing pliers. Cut off any excess
wire.
1
. Guide one end of the wire through the
3
1 right behind the head hole
to secure the screw.
1
. Secure the front head hole screw
2
2 over a length of approx. 5 cm.
onto the ends of the seal wire and press
G12354
up to the rear head
up to the front head
as
2
1 seal