Fct400 Transmitter With Single-Compartment Housing - ABB CoriolisMaster FCB100 Instruction Manual

CORIOLISMASTER FCX100, FCX400 SEALING OF DEVICES | IN/FCX100/FCX400/MID/OIML-XA REV. A
7. Continue to twist the seal wire
hole screw 2 . Secure the front head hole screw
described previously.
1
2
Fig. 22
8. Continue to twist the seal wire
on the lower cover. Guide one end of the wire through
the eyelets on the cover and housing, guide the other
end on the outer side near the eyelets. Tightly twist the
seal wire 1 right after the left eyelet
9. Continue to twist the seal wire
eyelet 3 . Secure the right eyelet
previously.
10. Tightly twist both ends of the seal wire after the right
eyelet over a length of approx. 5 cm.
3
11. Place the seal 4 approx. 5 cm from the last eyelet
onto the ends of the seal wire and press together using
sealing pliers. Cut off any excess
1 up to the front head
2 as
4
1
3
G12362
1 to the left eyelet 2
2 .
1 up to the right
3 as described
3
seal wire.
1
3.6 FCT400 transmitter with single-compartment
housing
NOTICE
Before the device is sealed, any settings must be
completed and the write protection switch must be set to
"write protection active" (see chapter 'Activating the
hardware write protection' on page 3 ).
Scope of delivery
Designation
Seal
Seal wire
1
3 4 2
Fig. 23
1. Insert the seal wire 2
upper eyelet such that both ends are the same
1
length.
2. Tightly twist the seal wire
eyelet .
1
3. Continue to twist the seal wire
eyelet 3 . Both ends of the seal wire must be very close
together and the twist loops should be smaller than 1
cm.
4. Secure the lower eyelet
5. Tightly twist both ends of the seal wire after the lower
eyelet 3 over a length of approx. 5 cm.
6. Place the seal 4 approx. 5 cm from the lower eyelet
onto the ends of the seal wire and press together using
sealing pliers. Cut off any excess
Quantity
1
1
through the openings on the
2 right after the upper
2 up to the lower
as described previously.
3
seal wire.
1
EN – 13
2
G12363
3