Introduction - KEB COMBISTOP 38 Instruction Manual

Introduction

1 Introduction
This instruction manual provides all information required to properly operate the KEB
brake and applies to the following brake types:
– COMBISTOP Type 38

COMBISTOP Type 38.11N
without hand release for dynamic applications (regular rated torque)
COMBISTOP Type 38.13N / DEN
with hand release for dynamic applications (regular rated torque)
COMBISTOP Type 38.11H
without hand release for static applications (enhanced rated torque)
COMBISTOP Type 38.13H / DEH
with hand release for static applications (enhanced rated torque)
The type designation can be found on the type plate and/or the code number.
The instruction manual must be read, understood and applied by all persons
responsible for the operation of the brake. This particularly applies to the safety
instructions herein.
After reading the instruction manual, you can
– operate the brake safely,
– perform maintenance work according to regulations,
take the corresponding measure in case of a malfunction.
–
Before starting to install the COMBISTOP type 38 brake, carefully read this instruction
manual.
The following sections describe the functional principle, the mounting and the basic
operation of the brake.
The information contained in the technical documentation, as well as any user-specific
advice in spoken and written form and through tests, are made to best of our
knowledge and information about the application. However, they are considered for
information only without responsibility. This also applies to any violation of industrial
property rights of a third party.
Inspection of our units in view of their suitability for the intended use must be done
generally by the user.
Application and use of our units in the target products is outside of our control and
therefore exclusively in the area of responsibility of the user.
In addition to this instruction manual, observe all applicable legal regulations and other
mandatory requirements applying to accident prevention as well as environmental
protection in the country of utilisation.
Always keep the instruction manual at the site where the brake is used.
01.09.2011 Rev. 01 COMBISTOP Type 38 Page 1