Mounting The Brake - KEB COMBISTOP 38 Instruction Manual

Mounting and Start-up
– The angular deviation of the mounting surface relative to the shaft must not exceed
the following values: Size 02 to 03: 0.04 mm; Size 04 to 05: 0.05 mm;
Size 06 to 07: 0.06 mm; Size 08 to 10: 0.08 mm; Size 11: 0.1 mm (in relation to the
mounting hole diameter).
4.1.2

Mounting the Brake

The following overview shows a detail of the fully assembled brake depending on its
design; i. e., with flange or with friction disc:
Brake with Flange and Dust Protection
Ring

If necessary, install the optional components such as friction disc, flange and dust
protection ring (4, 5 and 7) on the motor bearing assembly.
01.09.2011 Rev. 01
Brake with Friction Disc and Dust
Protection Ring
Step 1:
Installing the Hub
Install the hub (2) on the motor shaft,
then secure the hub on the motor shaft
axially.
The hub and the linings must not be
damaged!
COMBISTOP Type 38 Page 12