Receiver Connections And Settings - GRAUPNER Hott GR-12L Quick Start Manual

Servo-conection
Plug the servos into the connector of the receiver. The socket is also polarized, pay attention to
the small lateral bevels. Contact should easily snap on no account force to the plug. The sockets
are labeled accordingly, the brown wire (-), red (+) and orange (signal). The servo connections of
Graupner HoTT 2.4 GHz receiver are numbered.
The channel 6 port can be programmed for the (digital) signal output.
Power-connection
No specifi c jacks are provided for connecting the battery. Connect the power supply to the preferred
/ the socket (s) that are close to the servos. If you want to connect several separate batteries, make
sure that the batteries have the same rated voltage and rated capacity. Not include different types
of batteries or batteries with different charge levels too greatly, since this may lead to short-circuit-li-
ke effects. Turn in such cases for safety voltage stabilizers such as PRX-5A receiver power supplies
(Order No. 4136) between battery and receiver.
receiver socket: Graupner/SJ(JR) Typ female 3 Pins
Receiver channels
CH 1
CH 2
CH 3
CH 4
CH 5
CH 6
2. Telemetry socket
The channel 5 is provided in the receiver with a „T" fl ag, it features the telemetry interface. Via the
telemetry interface optional telemetry sensors can be used, fi lled with the latest fi rmware update or
the recipient of a SMART BOX programming. If the telemetry connector is used by sensors it can
no longer be used for a servo.

Receiver Connections and Settings

Funktion
signal output
signal output
signal output
signal output
signal output
signal output
Seite 2
Telemetrie port
(Channel 5)
Servosocket
Channel 1 ~ 6
Alternativ
Telemetrie, Firmware update
SUMD output
Graupner S/J
-
-
-
-