Table of Contents
Advertisement
If the face of the workpiece will only be par-
tially removed, observe the following steps:
1.
Follow Steps 1–4 on Page 28.
2.
Set fence faces so they barely clear cutter.
This allows maximum support possible for
workpiece when passing the cutter.
3.
Adjust outfeed fence face to same plane as
infeed fence. Remember to tighten fence fac-
ing before starting shaper.
4.
Turn shaper ON.
5.
Run a test piece through shaper (see
Figure 33).
Outfeed
Fence
Figure 33. Partial feed fence adjustment.
6.
Turn shaper OFF.
The sound of this machine when it is run-
ning may be less than that of other devices
such as a dust collector, which may be run-
ning at the same time. Because of this, it
may be difficult to determine if the machine
is ON merely by listening. It is neces-
sary to make certain that this machine is
OFF before attempting any setup or adjust-
ments. Otherwise, serious personal injury
could occur.
Model G0900 (Mfd. Since 03/20)
End View
Infeed
Fence
Direction of Feed
Always cut the end grain first when putting an
edge around the perimeter of your workpiece
to minimize tearout (see Figure 34).
Figure 34. Cut end grain first.
Digital Readout
Operation
To use digital readout:
1.
Use 0" SET button to precisely return spindle
elevation height to 0" (see Figure 35).
2.
Press mm/in. button to display height in either
inches or millimeters. Selected unit will be
illuminated (see Figure 35).
3.
Use spindle handwheel to change spindle
height, observing DRO screen until desired
height is achieved (see Figure 35).
Inch/Millimeter
Display
Zeroing Button
In./Mm. Button
Figure 35. DRO components.
1
4
3
2
Direction of Feed
DRO Screen
-29-
Advertisement
Table of Contents
