Table of Contents
Advertisement
Digital Readout
The model G0794 is equipped with a digital read-
out (DRO) for precision spindle adjustment. The
DRO is independently powered by a SR44 but-
ton cell battery, which may need to be changed
from time to time. Follow the instructions below to
change the battery.
Tools Needed:
Phillips Head Screwdriver #2 ............................ 1
To change DRO battery:
1.
DISCONNECT
DRILL
POWER!
2.
Remove (1) shoulder screw, then remove (4)
M5-.8 x 14 Phillips head screws shown in
Figure 4 and remove DRO housing.
x 4
x 1
Figure 4. Location of DRO mounting screws.
Model G0794 (Mfd. Since 05/18)
Qty
PRESS
FROM
3.
Remove (4) M4 x 12 tap screws shown in
Figure 5, and remove DRO unit from hous-
ing.
x 4
Figure 5. DRO housing removed from drill press
head.
4.
Lay DRO unit on a flat surface and remove
battery cover, as shown in Figure 6.
Figure 6. DRO battery cover removed.
5.
Replace battery with new SR44 button cell
battery and re-install battery cover.
6.
Re-install DRO unit and DRO housing, mak-
ing sure to re-install shoulder screw from
Step 2.
DRO Unit
Battery
Battery Cover
-5-
Advertisement
Table of Contents
