Table of Contents
Advertisement
Adjusting
Table Inserts
The removable table inserts are held in place by
a semi-permanent insert ring, which should be
adjusted level with the table top. This is necessary
to avoid the workpiece catching on the insert or
ring during operation, causing an unsafe condition
and poor cutting results.
Tools Needed
Flat Head Screwdriver #1 .................................. 1
Hex Wrench 2mm .............................................. 1
Precision Straightedge ...................................... 1
To make insert and insert rings level with table
top:
1.
DISCONNECT MACHINE FROM POWER!
2.
Remove two smaller table insert.
3.
Lay straightedge across semi-permanent
insert and table surface in pattern shown in
Figure 68.
Table Surface
+
+
Figure 68. Straightedge pattern.
-48-
Qty
Phillips Head
Screws (1 of 3)
+
Table Insert
Straightedge
4.
Adjust flat head screws (see Figure 69) so
that ends of straightedge lay flat on table sur-
face at all positions of pattern in
Figure 69. Example of table insert adjustment.
IMPORTANT: Table insert and surface must
be aligned evenly to ensure workpiece does
not catch on table insert or surface and kick
back.
5.
Replace smaller table inserts, one at a time,
then use the straightedge to re-check the
inserts. If necessary, adjust set screws in
inserts to seat them level with table in all
directions using the same technique as
Step 4.
Model G0900 (Mfd. Since 03/20)
Figure
68.
Advertisement
Table of Contents
