Zeroing Out Fence - Grizzly G0900 Owner's Manual

Zeroing Out Fence Steps

Zeroing Out Fence

The G0900 features forward and backward
spindle rotation; either fence face can function as
the infeed or outfeed fence. However, the scales
indicating the fence face placement on the fence
assembly need to be accurately calibrated to
allow for accurate micro-adjusting. The factory
made these adjustments during production, but
you may need to adjust the settings if they have
been altered.
Tools Needed
Hex Wrench 3mm .............................................. 1
Socket or Wrench 10mm ................................... 1
To calibrate scales:
1.
Unlock both fence lock handles and turn both
microadjustment knobs fully counterclock-
wise (see Figure 70).
— If fence scales both indicate 0", no calibra-
tion is required.
— If fences display different measurements
on scales, proceed to the following steps
to calibrate.
Model G0900 (Mfd. Since 03/20)
2. Loosen gib adjustment set screws and hex
nuts on fence or fences that do not display 0"
(see Figure 70).
Micro-Adjustment
Knob
Qty
Figure 70. Gib adjustment settings location.
3.
Use fence micro-adjusment knobs to adjust
fences until 0" measurement is achieved on
both sides.
4.
Tighten gib adjustment hardware to secure
setting.
5. Proceed to Aligning Fence Faces to ensure
fence faces are parallel.
Lock Handle
Gib Adjustment
Hardware
-49-