Lubrication - Grizzly G0900 Owner's Manual

Lubrication

Since all bearings on the G0900 are sealed and
permanently lubricated, simply leave them until
they need to be replaced. DO NOT lubricate them.
Below is a list of components that require periodic
lubrication. Do not over-lubricate these compo-
nents. Large amounts of lubricant will attract
sawdust, causing the metal components to gum
up and bind.
Items Needed
Hex Wrench 4mm .............................................. 1
Mineral Spirits .................................... As Needed
Shop Rags ......................................... As Needed
Lubrication Type ... T26419 or NLGI#2 Equivalent
—Amount..............................................Thin Coat
—Frequency ...................................... As Needed
T26419—Syn-O-Gen Synthetic Grease
Figure 61. T26419 Syn-O-Gen Synthetic
Grease.
Elevation Leadscrew & Spindle Slides
1. DISCONNECT MACHINE FROM POWER!
2. Lower spindle housing assembly fully by
turning handwheel counterclockwise.
3.
Use rag and mineral spirits to clean away
grease and built up grime from surfaces of
both slides and threads of leadscrew (see
Figure 62).
Model G0900 (Mfd. Since 03/20)
Lubrication Steps
4.
Use rag and mineral spirits to clean away
grease and built up grime from surfaces of
both slides and threads of leadscrew (see
Figure 62).
Qty
Figure 62. Spindle slide and leadscrew location.
5. Apply a thin coat of lubricant to slides and
leadscrew.
6. Use handwheel to fully raise and lower
spindle housing to distribute grease.
Fence Rack & Pinion
1. DISCONNECT MACHINE FROM POWER!
2. Unlock guard and fence assembly from table
by loosening lock knobs pictured below in
Figure 63.
Fence Assembly
Adjustment Knob
Figure 63. Fence rack and assembly location.
Leadscrew
Fence/Guard Assembly
Rack
Lock Knobs (1 of 2)
Slide
-43-