Stereo Groups - Solid State Logic ORIGIN User Manual

Origin Stereo Groups

Stereo Groups

Origin has eight Stereo Groups in the centre of the console. These are stereo 'audio' groups, i.e. they have audio passing through their faders,
as opposed to being VCA control groups. The inputs to these groups are via two DB-25 connectors on the rear of the console labelled ST GRP
IP 1-8 and ST GRP IP 9-16. This is because typically they are connected to the 16 console Track Buses, either directly via a DB-25 to DB-25 link
connector, or more typically via a patchbay. An overview of the Track Buses and Stereo Groups is shown in the block diagram below.
SLATE
BUS 1 SEND OUT
TONE
TRIM
TRACK BUS 1
±20dB
BUS 2 SEND OUT
TRIM
TRACK BUS 2
±20dB
Track Buses
(1-16)
SLATE
OSC
SLATE
18
INPUT
+
BUS SENDS CONNECT
+
TO STEREO GROUP IPs
VIA DB-25 LINK
-
-
OR HALF NORMALLED
PATCH ROW
+
+
-
-
MONO L MONO R
+
Stereo Groups
(A-H)
L R L R MIX MIX
L R L
0dB MUTE
BALANCE
MIX
to +3dB
+3dB to
SOLO
ORIGIN User Guide
AFL AFL PFL
R M
+
SUBGROUP
- 1L OUT
+
SUBGROUP
-
1R OUT
+
SUBGROUP
- 8L OUT
+
SUBGROUP
-
8R OUT