Mon (Monitor) Input - Solid State Logic ORIGIN User Manual

MON (Monitor) Input

The line level Monitor input is via a DB-25 connector (Mon Line In) also mounted on the rear of the console. Typically these inputs
will be wired to a patchbay (see Appendix F). Nominally this input is at unity gain, with a +20 db to -20 dB gain TRIM adjustment
to compensate for lower or higher Line level signals.
PATH FLIP
By default, the CHAN input feeds the Small Fader (SF) path and the MON input feeds the Large Fader (LF) path. This is indicated
by the red and green LEDs that bridge the line between these two sets of input controls. This default routing can be swapped by
using the PATH FLIP switch. When this switch is pressed, the red and green LEDs also flip status to show the path routing of the
input sections. This philosophy is repeated through the channel strip sections i.e.
LED : Small Fader Path
RED
LED : Large Fader Path
GREEN
Channel Input Block Diagram
CHANNEL
INPUT
48V
MIC
+48V
LINE
10K
ORIGIN User Guide
MONITOR
INPUT
+
MONITOR
-
GAIN
LINE
+dB
1.5K +2 to +70dB
[-12 to +55dB]
-10dB
TRIM
± 20dB
CHAN
METER
DRIVE
-1
Detailed Channel Description
MON
METER
PATH
FLIP
LF
Large Fader Path
ø
SF
Small Fader Path
5