Xerox WorkCentre PE114e Service Manual page 50

Disassembly and Reassembly
5.7 Exit Roller
1. Before you remove the Exit Roller you should remove:
- Rear Cover (see page 5-2)
- Side Covers (see page 5-3)
- Scanner Ass'y (see page 5-4)
- Middle Cover (see page 5-6)
5.8 LSU
1. Before you remove the LSU you should remove:
- Rear Cover (see page 5-2)
- Side Covers (see page 5-3)
- Scanner Ass'y (see page 5-4)
- Middle Cover (see page 5-6)
2. Unplug 2 connector from the LSU.
Service Manual
5-10
2. Remove the white Exit Gear, and release a bearing
clip at one end then remove the shaft and rollers as
shown below.
Exit Gear
Bearing
1
2
3. Unplug 4 screws and take the LSU out.
Exit Roller
LSU