Reg 1Ch Phase Detector Csp Register; Reg 1Dh Vco Tune Port Control Register; Reg 1Eh Temperature Sensor Register - Infinite Pasternack PE11S100 Series User Manual

User Manual | PE11S100X Series Synthesizer

7.30 Reg 1Ch Phase Detector CSP Register

Bit Type
3:0 R/W pfds_sat_deltaN
4 R/W pfds_rstb_force
5 R/W pfds_rstb

7.31 Reg 1Dh VCO Tune Port Control Register

Bit Type
0 R/W voltage_force
1 R/W voltage_enable

7.32 Reg 1Eh Temperature Sensor Register

Bit Type
0 R/W tsens_spi_enable
28
Name Default
0
0
1
Name Default
1
0
Name Default
0
x1x = disable GPO2 pad driver 1xx = disable
GPO3 pad driver
Description
0= Cycle Slip Prevention (CSP) disabled
4-bit value to advance or retard phase detector
in VCO cycles if it reaches 2pi, i.e. cycle slip
prevention. 1st bit is polarity, enabled by rstb
CSP PFD Flip-flops RSTB:
1 - controlled by the pfds_rstb bit: 0 - auto-
controlled by the CSP logic
Forces the PFD into reset, which tristates
charge pump, freezes charge on the loop filter,
and hence opens the loop
CSP PFD FF rstb
1 - Enables the Cycle Slip Prevention (CSP)
feature of the PFD
Description
Selects the source of control of the timing of the
mid-rail voltage,
voltage_force=0 selects Autotune state machine
voltage_force=1 selects voltage_enable from
SPI Used for mid-rail control of VCO during
autotuning
Forces mid-rail voltage on the charge pump
output from the SPI when voltage_force=1 Used
for mid-rail control of VCO during autotuning
Description
Enable the temperature sensor, draws ~2mA
current, must strobe tsens_spi_strobe Reg 00h
<3>
pasternack.com