Table of Contents
Advertisement
Innovative Photonics
Power -
Ensure that the power cord is inserted completely into the IEC connector on the back of the unit, and is
connected to a power supply as specified on the rear panel. Check power cord for damaged or severed
areas. Replace if defective.
Parts-
Inspect the unit for burned or damaged components. Contact the factory if visible damage has been done
to any of the components on the printed circuit board or any other components in the case.
Fuse -
Remove power cord from IEC connector. Check fuse(s) using the procedure in this manual. Replace
with spare fuse(s) as required. REPLACE ONLY WITH FUSE TYPE DESCRIBED ON THE REAR
PANEL OF THE UNIT. If unit blows another fuse, consult factory for service.
If unit cannot be made operational using above procedures, call factory for servicing.
Revision 2 09/01/16
Illumination
Technologies, Inc.
Illumination Technologies, Inc.
102 Route 5 West, Building 2, Elbridge, NY 13060 USA
www.illuminationtech.com
Owner's Manual
Page 26 of 28
Advertisement
Table of Contents
