Table of Contents
Advertisement
Innovative Photonics
Ethernet Option
The command structure for the Ethernet interface is exactly the same. However, the unit's Ethernet module
must be set to the proper IP address to communicate within your specific network.
To identify and update the IP address of the Ethernet device to your network, you will need to do the
following:
1. Download and installing the Lantronix Device Installer software
2. Check the current IP settings of your network and the lightsource
3. Changing the lightsource settings to match your network requirements
We use the Lantronix network interface module, which is supported by the Lantronix Device Installer
software. Follow this link to download the latest version of the required software:
http://ltxfaq.custhelp.com/app/answers/detail/a_id/644/session/L3NpZC9kWWlqWjRsaw%3D%3D
*Note: If your security settings do not allow downloading and installing software, please contact
your network administrator for assistance.
The above link should take you to the following webpage:
Click the link for "Standalone DeviceInstaller Setup application for Windows". Download the
application via HTTP.
Revision 2 09/01/16
Illumination
Technologies, Inc.
Illumination Technologies, Inc.
102 Route 5 West, Building 2, Elbridge, NY 13060 USA
www.illuminationtech.com
28
Owner's Manual
COMMUNICATIONS
Click
Here
Page 12 of
Advertisement
Table of Contents
