Table of Contents
Advertisement
Innovative Photonics
CAUTION:
Read all of these instructions before operating the unit.
Follow all warnings and instructions on this piece of equipment
Failure to use this equipment in the manner specified in this manual may cause the protection features of the unit to be
impaired.
1.
Retain Instructions - All safety and operating instructions
should be retained for future reference.
2.
Follow Instructions - All operating and use instructions should
be followed.
3.
Water and Moisture - The unit should not be used near water,
or in any area where excessive moisture may come in contact
with the unit.
Eau Et Moisissure: Le système ne doit pas être utilisé prés de
l'eau, ou dans un environement où la moisissure pourait venir en
contact avec le système.
4.
Mounting - The unit should be mounted horizontally on a
surface or platform, or vertically via fixture only as
recommended by the manufacturer. Never mount with fiber
receptacle pointing down.
5.
Ventilation - The unit should be positioned such that its
surroundings do not interfere with its proper ventilation.
Ensure that there is adequate air flow below (intake) and in
the rear (exhaust) of the unit.
6.
Heat - The unit produces heat and infrared radiation. Do not
place flammable materials on or near the unit at any time. Keep
unit away from other sources of heat. Always allow time for the
lamp and all surfaces surrounding the bulb to cool before
attempting to replace lamp.
Chaleur: Le système développe de la chaleur et des radiations
infrarouge.
Ne pas placer de materiaux flammables sur le
système ou proche quelquesoit le moment. Toujours prévoir du
temps pour la lampe et les surfaces avoisinant la lampe pour
refroidir avant d'essayer de remplacer la lampe.
7.
Power Source - The unit should be connected to a power source
only of the type described in the operating instructions and as
indicated by the power entry module.
8.
Grounding - Precautions should be taken to ensure that proper
grounding of the unit is assured.
9.
Power Cord - Use only the approved power cord supplied with
the unit, or an equivalent IEC 320 power cord with proper
certifications. Power cord should be routed such that it will not
be pinched, severed or walked on.
Revision 2 09/01/16
Illumination
Technologies, Inc.
Illumination Technologies, Inc.
102 Route 5 West, Building 2, Elbridge, NY 13060 USA
www.illuminationtech.com
Owner's Manual
10. Fuse - DO NOT DEFEAT FUSE. Replace only with fuses as
described in the operating manual and as marked on the unit for
the operating voltage that the unit is set for.
11. Cleaning - The unit should be externally cleaned using only
standard glass type cleaners. Do not use solvents, cleansers or
petroleum distillates. Disconnect power cord before performing
any cleaning operations.
12. Liquid and Object Entry - Care should be taken to avoid
objects falling into, or liquids being spilled into the enclosure
through openings.
13. Nonuse Periods - Disconnect power cord from outlet when unit
will be left unused for a long period.
14. Damage Requiring Service - The unit should be serviced by
qualified service personnel if it exhibits any marked change in
performance; if the power cord or enclosure has been damaged;
or if objects or moisture have entered the unit.
15. Servicing - The user should not service the unit beyond that
described in this manual. All other servicing should be referred
to qualified service personnel. Disconnect power cord before
performing any service on the unit.
16. Cover must be removed to replace the lamp. Never remove
cover before disconnecting the IEC 320 power cord.
Safety Instructions
Page 2 of 28
Advertisement
Table of Contents
