Table of Contents
Advertisement
Innovative Photonics
Upon restart you will be asked to select a destination to save the program. By default, the Windows
installer selects the path shown. You can accept the default or browse to find a more suitable location if
you desire. You should make note of where you install this program to for future reference.
Select Next and Confirm the installation. Once the installation process is complete select Close and you
will receive the successful installation window:
The DeviceInstaller is now installed on your computer and ready for you to use.
Connect the power to the device and power on. Connect an Ethernet cable from the lightsource to a
network switch or hub into which this same computer is also attached. Ensure that the GREEN
LED light on the lightsource Ethernet port is lit (indicates that the lightsource's Ethernet port is
powered). The YELLOW LED should flash whenever a command is sent to the Ethernet port.
You
can
now
launch
Programs/Lantronix/DeviceInstaller 4.3/DeviceInstaller (if you receive an error message from your
firewall, you will need to allow the DeviceInstaller to have access to the Internet):
Revision 2 09/01/16
Illumination
Technologies, Inc.
DeviceInstaller
in
Illumination Technologies, Inc.
102 Route 5 West, Building 2, Elbridge, NY 13060 USA
www.illuminationtech.com
28
Owner's Manual
the
"Start"
Menu
as
shown
under
Page 15 of
Advertisement
Table of Contents
